Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Windshield Washer Fluid Reservoir on the Volvo XC60

Model: Volvo Xc60 MK 1 - Years 2008-2016

Today, let's go through the steps to remove and replace the windshield washer fluid reservoir on the Volvo XC60. First, open the hood of the vehicle and start removing the front bumper by unscrewing all the mounting screws you find on the top and bottom; you will find the windshield washer fluid reservoir at the back, as shown in the video. At this point, disconnect the hose and the electrical connector of the washer pump, unscrewing the screws to remove it and replace it with the new one; reassemble and reconnect everything, finally securing the front bumper!

Updated on 14 September 2026 by ScegliAuto

Video tutorial

Related tutorials

Where are the fuses located in the Volvo XC60?
Where are the fuses located in the Volvo XC60?
Volvo Xc60 (2017-2026 / MK 2) Any fuse of the Volvo XC60 will be contained inside one of the special fuse boxes that are present in the car: on this type of vehicle it will be pos…
How to Top Off the Engine Oil of the Volvo XC60?
How to Top Off the Engine Oil of the Volvo XC60?
Volvo Xc60 (2008-2016 / MK 1) To top off the engine oil of the Volvo XC60, open the hood to access the components in the engine compartment. In the center of the engine block, loc…
Where are the fuses in the Volvo XC60?
Where are the fuses in the Volvo XC60?
Volvo Xc60 (2017-2026 / MK 2) The Volvo XC60 has one of the highest numbers of fuse boxes on board. The first two can be found inside the engine compartment, both just below the w…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos