Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Alfa Romeo
    3. :
  3. 147
    4. : Guide to disassembling the EGR valve

Alfa Romeo 147 - Video tutorial

Model: Alfa Romeo 147 MK 1 - Years 2000-2010
Part: EGR valve
Operation: Guide to disassembling the EGR valve

The necessary is a 13 mm wrench, an 8 mm wrench and a 13 mm angular wrench. Disassemble the monobloc cover and remove the support shown in the video later, with the 13mm wrench proceed to disassemble the valve, two screws with the normal wrench and two to unscrew with the angle wrench, be careful not to lose the metal gasket present, finally unscrew the other two screws on the upper part of the valve, being careful here too not to lose the gasket present. Following the video step by step, the operation takes less than 10 minutes and you can then proceed with cleaning or replacing the EGR valve. The procedure to follow is the same for the Alfa Romeo 147, Alfa GT and Fiat Stilo 1.9 JTD 16V


Posted on 22 June 2023 by ScegliAuto



How to remove the EGR valve of an Alfa Romeo 147
Alfa Romeo 147 (2000-2010 / MK 1) Before starting, we will have to open the front hood of our Alfa Romeo 147. Let's start by unscrewing and removing the screws that fix the hoses to t
How to disassemble the EGR valve of the Alfa Romeo 147
Alfa Romeo 147 (2000-2010 / MK 1) Below we will see the procedure that will allow us to disassemble and replace (or clean) the EGR valve of the Alfa Romeo 147. First, we open the car'
Removal of the EGR valve of the Alfa Romeo 147 1.9 JTDM
Alfa Romeo 147 (2000-2010 / MK 1) In this video tutorial we will see how to disassemble and replace the EGR valve of the Alfa Romeo 147 1.9 JTDM, following these simple steps. First o

    Frequently Asked Questions

    • 147 2000-2010 - How much does the Alfa Romeo 147 EGR valve cost? Read Answer
    • 147 2000-2010 - Where is the Alfa 147's EGR valve located? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos