Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installing a Rear Camera on License Plate Lights

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Accessory kit

You can purchase an aftermarket camera mounted on a bracket to replace the one for the rear license plate lights: you will need to remove the cover panels of the trunk.
First, unscrew the 4 screws located just below the tool storage compartment; remove the two pressure clips along the edge of the trunk (near the rubber stops); remove the protective cover of the screw inside the handle used to close the trunk and unscrew the screw itself;
Then, detach and remove the rear part of the trunk cover; disconnect the socket of the internal trunk light and then the other cover.
At this point, remove the license plate light bracket and replace it with the one equipped with a camera; connect the wires according to the attached diagram and route the wiring to reach the fuse box inside the trunk. Connect the camera's power supply to the reverse light bulb to activate the camera when the reverse gear is engaged. Finally, connect the RCA input jacks.
Reassemble the previously removed panels.

Updated on 3 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Install a Camera on BMW 3 Series
How to Install a Camera on BMW 3 Series
BMW Serie 3 (2005-2013 / E91, E90, E92) Let's see how to install the camera (where the license plate light is located) in the trunk of a BMW 3 Series. First, open the trunk of the car, then…
How to Install the Backup Camera on a BMW 3 Series?
How to Install the Backup Camera on a BMW 3 Series?
BMW Serie 3 (2005-2013 / E91, E90, E92) To install the backup camera on a BMW 3 Series, open the rear hatch by unscrewing the screws that secure the corresponding panel inside. Once the pan…
Installation of the rear camera of the BMW 3 Series
Installation of the rear camera of the BMW 3 Series
BMW Serie 3 (1998-2006 / E46) Following these simple steps, we will see how to install the rear camera useful for parking maneuvers on the BMW 3 Series. First of all, we get on bo…

Other guides you may be interested in

How to reset the tyre pressure warning light on the Suzuki Jimny?

To reset the tyre pressure warning light on the Suzuki Jimny, first inflate the tyres to the pressure value indicated on the corresponding sticker: this is located at the bottom of the driver's door pillar. Once the tyres are inflated, insert the ignition key and turn on the instrument panel: select the screen that indicates the tyre pressures, checking that the values change. After a few seconds, the tyre pressure warning light will automatically turn off.

Watch the video!


by ScegliAuto

More videos