Do it yourself
Frequently asked questions about cars and motorcycles

Check Engine Oil Level on BMW 3 Series

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Checks and maintenance

Check the engine oil level on a BMW 3 Series. Open the car door, pull the plastic lever located at the bottom left of the dashboard, and lift the hood. Locate the dipstick with the ring to pull it out; remove it and check the oil level (there are specific marks for minimum and maximum). Wipe it with a cloth to remove any oil residue; insert and remove the dipstick again. If the oil is at the low level on the dipstick, add oil (use the correct type of oil). Recheck the engine oil level and close the hood.

Updated on 17 March 2026 by ScegliAuto

Video tutorial

Related tutorials

BMW Serie 3 (1998-2006 / E46) Today, in this brief and simple guide, you will learn how to check the engine oil level of the BMW 3 Series by following the instructions below. Firs…
BMW Serie 3 (2005-2013 / E91, E90, E92) In order to check the oil level of the BMW 3 Series engine, you need to open the hood so that you can access the internal components of the engine co…
BMW Serie 3 (1998-2006 / E46) Check the engine oil level on a BMW 3 Series. Open and lift the hood. Locate the dipstick with the ring to pull it out; remove it and check the oil l…

Other guides you may be interested in

    Frequently Asked Questions

    • Serie 3 2012-2019 - How much does a service cost for the BMW 3 Series? Read answer
    • Serie 3 2005-2013 - Why is the on-board computer of the BMW 3 Series slow to start up? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos