Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Camshaft Position Sensor on the BMW 3 Series?

Model: BMW Serie 3 E91, E90, E92 - Years 2005-2013
Part: Checks and maintenance

In this tutorial, you will see how to remove the camshaft position sensor on the BMW 3 Series E90, a very simple operation. First, remove the entire rear cover of the engine bay, then also remove the wiring harness channel located beneath it. Next, unscrew the mounting bolts of the front intake manifold, disconnect the sensor, and remove the entire air filter box to gain workspace. For the same reason, remove the brake fluid reservoir from its bracket. At this point, you can finally remove the sensor by unscrewing the respective bolts.

Updated on 6 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Camshaft Position Sensor on a BMW 3 Series
How to Replace the Camshaft Position Sensor on a BMW 3 Series
BMW Serie 3 (1998-2006 / E46) In this guide, we will look at the instructions that will allow you to remove and replace the camshaft position sensor on a gasoline BMW 3 Series. Fi…
How to Test the Camshaft Sensor on a BMW 3 Series?
How to Test the Camshaft Sensor on a BMW 3 Series?
BMW Serie 3 (2005-2013 / E91, E90, E92) To test the camshaft sensor on a BMW 3 Series, completely remove the front part of the car by taking off the bumper for easier access to the engine. …
Instructions for Disassembling the Camshaft on BMW 3 Series 330i E46
Instructions for Disassembling the Camshaft on BMW 3 Series 330i E46
BMW Serie 3 (1998-2006 / E46) In this video, you will see how to disassemble the camshaft from the cylinder head on a BMW 3 Series 330i E46; in this case, we will only cover the s…

Other guides you may be interested in

    Frequently Asked Questions

    • Serie 3 2012-2019 - How much does a service cost for the BMW 3 Series? Read answer
    • Serie 3 2005-2013 - Why is the on-board computer of the BMW 3 Series slow to start up? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos