Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : How to disassemble the automatic transmission of the BMW 3 Series

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Gearbox
Operation: How to disassemble the automatic transmission of the BMW 3 Series

Let's see in this guide how to disassemble and remove the BMW 3 Series gearbox, following the instructions below. First we raise the car and start unscrewing the fixing screws of the metal supports that we find under the gearbox; then unscrew the fixing screws of the transmission shaft support, as shown in the video. Now disconnect the oil pipe and drain it; we then unscrew the screws of the gearbox, separating it from the engine, disconnecting the electrical connector to remove the gearbox.


Posted on 10 September 2022 by ScegliAuto

    Frequently Asked Questions

    • Serie 3 2012-2019 - What to do if the automatic gearbox on the BMW 3 Series F30 does not work? Read Answer
    • Serie 3 2012-2019 - How much does an automatic transmission oil change cost on a BMW 320d? Read Answer
    • Serie 3 1998-2006 - Why is the automatic transmission of a BMW 3 Series blocked? Read Answer
    • Serie 3 2005-2013 - How much does the BMW 3 series e92 automatic transmission oil filter cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos