Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : How to reset the service light on Bmw 320d e90

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E92, E91, E90 - Years 2005-2013
Part: -board computer
Operation: How to reset the service light on Bmw 320d e90

To reset the oil change service warning light on Bmw 320 e90 series it is necessary to follow the procedure below: open the door on the driver's side and access the driver's seat. Press the "start engine" control, locate the control lever on the left side of the steering wheel and "shake" the wheel upwards or downwards until you reach the "service info" function. After that, press the control located at the end of the control lever to the left of the steering wheel for at least 10 seconds and wait for the warning light to go out. To check that the warning light has been correctly reset, switch the ignition off and on again.


Posted on 21 October 2022 by ScegliAuto

This video is currently unavailable

Other guides that may interest you

    Frequently Asked Questions

    • Serie 3 1998-2006 - What to do if the on-board computer on your BMW 3-series E46 no longer works? Read Answer
    • Serie 3 2019-2026 - How to reset the brake light on BMW 3 series? Read Answer
    • Serie 3 2005-2013 - Why does the BMW 3 Series navigator stop working? Read Answer
    • Serie 3 2012-2019 - What does the message "water in the tank" mean in my BMW 3 Series? Read Answer
    • Serie 3 2012-2019 - What to do if the brake pad reset does not work in a BMW? Read Answer
    • Serie 3 2012-2019 - What warning lights are there in the dashboard of the BMW 3 Series? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos