Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 1
    4. : Reset the service light on Bmw 1 Series 2016

BMW Serie 1 - Video tutorial

Model: BMW Serie 1 F20, F21, MK 2 - Years 2011-2019
Operation: Reset the service light on Bmw 1 Series 2016

Each registered car, after a number of time or kilometers, requires a coupon (or Service) or the replacement of filters and engine oil. To signal this, the car turns on a warning light on the panel which can be deactivated in the event of a service being carried out or to be carried out shortly. To disable this warning light on BMW 1 Series follow these simple steps. First, press the power button without pressing the clutch and hold the button at the bottom left of the dashboard. After a few seconds, a new message will appear on the screen indicating the number of km traveled since the warning light came on. At this point, release the button and press it again. After a few seconds the operation will be confirmed and the reset of the other lights will appear. To complete the operation, turn off the car ignition with the key.


Posted on 10 November 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Serie 1 2011-2019 - How does the DTC work on the BMW 1 Series? Read Answer
    • Serie 1 2011-2019 - How to open the roof of the BMW 1 Series? Read Answer
    • Serie 1 2011-2019 - Why is the BMW 1 Series reversing radar not working? Read Answer
    • Serie 1 2011-2019 - Why doesn't the BMW 1 series turn on? Read Answer
    • Serie 1 2011-2019 - How many km can a BMW 1 series travel? Read Answer
    • Serie 1 2004-2013 - Where is the power steering fluid reservoir located in a 2007 BMW 1 Series? Read Answer
    • Serie 1 2004-2013 - Where is the color identification number on the BMW 1 Series? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos