Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Headlight Lever for Turn Signals on the Chevrolet Equinox

Model: Chevrolet Equinox MK 1 - Years 2005-2009
Part: Push button

The video shows how to replace the headlight lever for the turn signals on a first-generation Chevrolet Equinox (2005-2009). It is a simple task that requires only a little time and basic skills. Remove the upper and rear part of the steering wheel by pressing the two side tabs to access the left lever. Firmly press the two tabs on the lever to remove it, and once removed, carefully disconnect the wires by pressing the tabs again. Connect them to the new lever and insert it, ensuring it clicks into place to lock it. Repeat the other steps in reverse as described during disassembly.

Updated on 31 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Where are the fuses located in the Chevrolet Equinox?
Where are the fuses located in the Chevrolet Equinox?
Chevrolet Equinox (2010-2017 / MK 2) The fuses in the Chevrolet Equinox are located within the dedicated fuse boxes present in the vehicle. This model has two: one is inside the cabin, o…
How to replace the rear taillight bulbs of the Chevrolet Equinox.
How to replace the rear taillight bulbs of the Chevrolet Equinox.
Chevrolet Equinox (2010-2017 / MK 2) Below we will see the instructions that will allow us to disassemble and replace the rear light bulbs of the Chevrolet Equinox. First, let's open the…
How to Replace the Rear Headlight Bulb on a Chevrolet Equinox?
How to Replace the Rear Headlight Bulb on a Chevrolet Equinox?
Chevrolet Equinox (2010-2017 / MK 2) To replace the rear headlight bulb on a Chevrolet Equinox, open the trunk to access the screws located between the headlight and the seal. After loos…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos