Do it yourself
| ||||
|
Fiat Multipla - Alternator
Fiat Multipla (1998-2010 / MK 1)
How to replace the alternator of the Fiat Multipla jtd. To replace the alternator of the Fiat Multipla jtd, we lift the front of the car from the right side, remove the right wheel, unscrew the screws to remove the …read all… Posted on 22 April 2023 by ScegliAuto
Fiat Multipla (1998-2010 / MK 1)
How to change the alternator of the Fiat Multipla If the warning light showing the battery symbol remains on on the instrument panel display, it means that the alternator is not recharging it and this may be …read all… Posted on 17 September 2023 by ScegliAuto
Fiat Multipla (1998-2010 / MK 1)
How to disassemble the alternator Fiat Multipla 1900 multijet In order to disassemble the alternator, it is suggested right away that it must be pulled out from below, passing it from behind the oil pan: it is therefore …read all… Posted on 3 September 2023 by ScegliAuto Airbags (1) Alternator (3) Battery (1) Gearbox (1) Key (1) Timing belt (1) V-belt (1) Air conditioning controls (1) -board computer (1) Checks and maintenance (4) Headlight (1) Fog lights (2) Cabin air filter (4) Clutch (1) Injectors (3) Headlight bulb (2) Rear light bulb (2) Interior lights ceiling light bulb (2) Dashboard light (1) Handle (3) Engine (1) Engine oil (2) Door panel (2) Brake pads (1) Hydraulic pistons (1) Fuel pump (1) Instrument cluster (1) Wheel (1) Fuse box (3) Seat (5) Engine head (1) EGR valve (1) |
Handbrake adjustment on Ford EcosportFirst remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.005
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |