Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil on a Fiat 500 Abarth

Model: Fiat 500 500 L - Years: 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
Part: Engine oil

See other generations:
Video tutorial

To change the engine oil on a Fiat 500 Abarth, slightly warm up the engine to make the lubricant more fluid, then turn it off and lift the vehicle safely. Remove any lower protection and place a container under the oil sump.

Unscrew the drain plug and allow the used oil to fully drain out. Once drained, clean the area around the plug, replace the gasket if required, and screw it back in properly. Lower the car and open the filler cap in the engine bay. Gradually pour in the new oil, adhering to the specification and quantity required for the engine.

Wait a few minutes and check the level using the dipstick, topping up if necessary without exceeding the MAX mark. Finally, start the engine for a few seconds, turn it off, and check the level again and for any leaks.


Posted on 28 August 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil on a Fiat 500 Abarth
How to Change the Engine Oil on a Fiat 500 Abarth
Fiat 500 (2007-2024 / 312) Today, you will learn the steps to change the oil on a Fiat 500 Abarth. The first step is to remove the bolt securing the oil sump located at the bot…
How to Reset the Service Light on a Fiat 500 Abarth
Fiat 500 (2007-2022 / 312) Below, we will see how to reset the service light for the engine oil change on the Fiat 500 Abarth. First, get into the vehicle and connect your diag…
How to Reset the Service Light on an Abarth 500
How to Reset the Service Light on an Abarth 500
Fiat 500 (2007-2021 / ) The video demonstrates the procedure to reset the Service light on an Abarth 500. Before performing this procedure, it is advisable to change the eng…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos