Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Coil Wires on a Fiat 600

Model: Fiat Seicento MK 1 - Years 1998-2010
Part: Ignition coil

Are the coils on your Fiat 600 damaged and the car won't start? Here’s how to replace them on a Fiat 600. Pull the engine compartment release lever located at the bottom left of the dashboard and lift the front bonnet, securing it in place. Remove the engine soundproofing panel (central panel), disconnect the coil's power connector, grasp the coil with your hands and twist it to extract it from the cylinder head. Connect the wire of the new coil to the electrical terminal and attach the coil to the spark plug. Refit the plastic cover panel that was removed earlier. Start the Fiat 600 and test it.

Updated on 16 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Headrest from a Fiat 600
How to Remove the Headrest from a Fiat 600
Fiat Seicento (1998-2010 / MK 1) Before you start, sit in the back seat of your Fiat 600. In the headrest support slots, there are small holes. Begin by inserting a suitable tool int…
How to Top Up the Windscreen Washer Fluid of a Fiat 600
How to Top Up the Windscreen Washer Fluid of a Fiat 600
Fiat Seicento (1998-2010 / MK 1) Before you begin, open the front bonnet of your Fiat 600. Start by unscrewing and removing the cap located near the right front headlamp. Then, inser…
Fitting Rear Bumper on Fiat 600
Fitting Rear Bumper on Fiat 600
Fiat Seicento (1998-2010 / MK 1) In this video, you will see how to fit the rear bumper on the small Fiat 600. First, insert the new bumper and start securing it by placing and tight…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos