Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Cylinder Head Gasket on a Fiat 600

Model: Fiat Seicento MK 1 - Years 1998-2010
Part: Cylinder head

In this video tutorial, you will learn how to replace the cylinder head gasket on a Fire engine, specifically for the Fiat 600. In the video, the engine is removed from the car, but the procedure is the same with the engine in place. First, remove the distributor cap and the cylinder head cover by unscrewing all the screws; this allows you to take off the distributor by hand. Next, loosen the tensioner by hand and remove the timing belt. Now, remove the camshaft and, using a socket wrench, unscrew all the head bolts. Lift the head and replace the gasket!

Updated on 19 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Coil Wires on a Fiat 600
How to Remove the Coil Wires on a Fiat 600
Fiat Seicento (1998-2010 / MK 1) Are the coils on your Fiat 600 damaged and the car won't start? Here’s how to replace them on a Fiat 600. Pull the engine compartment release lever l…
How to Remove the Cylinder Head of a Fiat 600
How to Remove the Cylinder Head of a Fiat 600
Fiat Seicento (1998-2010 / MK 1) Let's see how to remove the cylinder head of a Fiat 600. Remove the soundproofing panel from the cylinder head (if present) and pull out the dipstick…
How to Remove the Headrest from a Fiat 600
How to Remove the Headrest from a Fiat 600
Fiat Seicento (1998-2010 / MK 1) Before you start, sit in the back seat of your Fiat 600. In the headrest support slots, there are small holes. Begin by inserting a suitable tool int…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos