Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : Replacing the oil and engine oil filter on Fiat 500 Abarth

Fiat 500 - Video tutorial

Model: Fiat 500 312 - Years 2007-2021
Part: Oil filter
Operation: Replacing the oil and engine oil filter on Fiat 500 Abarth

Start the engine for a few minutes to heat the oil in circulation and facilitate its subsequent leakage. Lift the hood and try to identify the position of the oil filter: as shown in the video, it is located on the left side of the vehicle but is rather hidden as it is low in relation to the engine. For this you will need a rather long key to get there. After replacing the filter, lift the car and unscrew the lower drain bolt from which you will drain the oil into a container. Close the hole and load the same amount of oil from the upper hole.


Posted on 2 February 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 500 2012-2023 - Where is the Fiat 500 L oil filter located? Read Answer
    • 500 2014-2022 - How do you replace the engine oil filter in the Fiat 500x Multijet? Read Answer
    • 500 2014-2022 - How to replace the oil filter on the Fiat 500X? Read Answer
    • 500 2014-2022 - How to replace the oil filter on the Fiat 500X? Read Answer
    • 500 2014-2022 - Where is the oil filter located in the Fiat 500L? Read Answer
    • 500 2007-2023 - Where is the Fiat 500 oil filter located? Read Answer
    • 500 2014-2022 - Where is the oil filter on Fiat 500x? Read Answer
    • 500 2014-2022 - How to replace the oil filter on Fiat 500X 1.6 mjt? Read Answer
    • 500 2014-2022 - How much is the oil filter of the Fiat 500 s 2017? Read Answer
    • 500 2007-2023 - Where is the Fiat 500 engine oil filter located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos