Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Punto
    4. : Replacement of spark plugs on Fiat Punto

Fiat Punto - Video tutorial

Model: Fiat Punto MK 2, 188 - Years 1999-2011
Part: Spark plugs
Operation: Replacement of spark plugs on Fiat Punto

In this short video tutorial we are going to see how to replace the spark plugs on a second generation Fiat Punto, model produced from 1999 to 2011. Let's start immediately by opening the bonnet and removing the entire filter box by unscrewing the two screws that hold it. in a position positioned above the engine. Now we are going to remove the four ignition coils of the spark plugs and using a socket wrench of sixteen with an extension to go and remove the spark plugs. Once all four spark plugs have been replaced, we reassemble the coils, the filter box and we are done with the job.


Posted on 18 April 2024 by ScegliAuto

    Frequently Asked Questions

    • Punto 2005-2018 - What causes the cold start problem of the Fiat Grande Punto 1.2 8V? Read Answer
    • Punto 1999-2011 - How much does it cost to replace the spark plugs on the Fiat Punto 1.3 multijet? Read Answer
    • Punto 1999-2011 - How much do the spark plugs on the 2001 Fiat Punto 1.2 ELX cost? Read Answer
    • Punto 1999-2011 - How much do the Fiat Punto spark plugs cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos