Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Wiper Control Lever

Model: Ford Ranger MK 2 - Years 1993-1997
Part: Windshield wipers

To remove the glove compartment, take off the upper plastic trim. To avoid leaving marks, use a plastic tool to also remove the trim on the steering wheel side. Unscrew all the screws located under the trims using a screwdriver with an extension. Unscrew the screws under the dashboard by pulling up the glove compartment lock. Remove the plastic clips and unscrew the screws located at the sides behind and underneath the plastic cover of the steering column. Once all screws are removed, you can extract the complete wiper control block for replacement.

Updated on 6 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Cabin Fan
Replacing the Cabin Fan
Ford Ranger (1993-1997 / MK 2) Open the front bonnet and ensure it is securely supported. To remove the cabin fan, it is necessary to detach the coolant and windscreen washer fluid…
Replacing the Cabin Fan Resistor
Replacing the Cabin Fan Resistor
Ford Ranger (1993-1997 / MK 2) First, open the front bonnet. The cabin fan is located on the left side (when facing the engine) just below the windscreen, behind the windscreen was…
How to Reset the Automatic Gearbox of the Ford Ranger?
How to Reset the Automatic Gearbox of the Ford Ranger?
Ford Ranger (2011-2023 / T6, P375, PX) If the automatic gearbox of the Ford Ranger is stuck, it obviously prevents the use of the vehicle. There is a procedure to reset it, which is outlin…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos