Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of Front Discs and Pads

Model: Ford Escort MK 4 - Years 1990-2000
Part: Brake rotors

Lift the vehicle on suitable axle stands and remove the front wheel. Disconnect the retaining spring and then remove the retaining pins of the brake pads to take them out. Unscrew the retaining bolts of the brake caliper and move it away from its support, then retract the piston using a C-clamp. Next, remove the brake disc, clean the hub support with a wire brush, and apply grease. Remove the protective oil from the new discs and fit them onto the hub. Also clean the brake caliper, apply copper grease, insert the new pads, and secure it to the support. Finally, insert the retaining pins of the pads and reconnect the spring. Be cautious during the first braking.

Updated on 16 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacement of Rear Brake Pads
Replacement of Rear Brake Pads
Ford Escort (1990-2000 / MK 4) First step: lift the vehicle and remove the wheel bolts and the wheel itself. Unscrew the drum screws and remove the drum. Spray the de-scaling fluid…
Front Wheel Bearing Replacement
Front Wheel Bearing Replacement
Ford Escort (1990-2000 / MK 4) Necessary tools: socket wrench, screwdriver set, hammer, and good quality synthetic grease. Obtain a replacement bearing. Lift the vehicle, secure it…
Where are the fuses of the Ford Escort located?
Where are the fuses of the Ford Escort located?
Ford Escort (1990-2000 / MK 4) The fuses of the Ford Escort are contained inside the appropriate fuse boxes that are installed on the vehicle: in this type of vehicle it will be po…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos