Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Land Rover
    3. :
  3. Range Rover
    4. : Alternator replacement on Range Rover Sport

Land Rover Range Rover - Video tutorial

Model: Land Rover Range Rover MK 3, L322 - Years 2002-2012
Part: Alternator
Operation: Alternator replacement on Range Rover Sport

Remove the ignition key, pull the handbrake and open the hood by supporting it with the special rod. Disconnect the negative pole of the battery by unscrewing it. Raise the car with a jack and go to work, from below, on the side relative to the right front wheel. Unscrew the bolts that secure the rear protection plates and remove them, as shown in the video. In the same way, remove the smaller guard located just below the alternator. Disconnect the two connectors that go to the alternator and unscrew the three bolts that secure it, finally extract the same. Proceed backwards for assembly.


Posted on 5 January 2024 by ScegliAuto



How to disassemble Range Rover Sport alternator
Land Rover Range Rover (2002-2012 / MK 3, L322) Let's see how the alternator is removed from inside the engine compartment of the Range Rover Sport. We lift the front hood, remove the cover panel t
How to set the time on a Range Rover Sport
Land Rover Range Rover (2012-2021 / MK 2) Before we can begin, we will have to go and sit in the driver's seat of our Range Rover Sport. Let's start by activating the on-board computer by pre
How to remove the rear lights in the Land Rover Range Rover Sport?
Land Rover Range Rover (2012-2021 / MK 2) In this tutorial we can see how to remove the rear lights in the Land Rover Range Rover Sport, a very simple and fast operation. Before proceeding, m

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos