Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to reset the AFS warning light on the Lexus RX

Model: Lexus RX MK 3, Al10 - Years 2008-2015
Part: Warning light – error code

The AFS warning light of the 2010 Lexus RX can only be reset by disconnecting the plug located next to the fuse box, located inside the cabin under the steering wheel. To perform the reset, unscrew the lower part of the dashboard using a Phillips screwdriver. After removing the cover, disconnect the plug and remove the fuse related to the warning light. By doing this, when the vehicle is turned on, the warning light will be off and deactivated. If you do not want to proceed differently, it is necessary to go to a workshop to perform a scan and reset of the control unit.

Posted on 6 December 2024 by ScegliAuto

Video tutorial

Related tutorials

How to reset the tire pressure light in the Lexus RX 350?
How to reset the tire pressure light in the Lexus RX 350?
Lexus RX (2016-2022 / MK 4, Al20) In this tutorial, we can see how to reset the tire pressure warning light in the Lexus RX 350, an extremely simple and quick operation, to be carried…
How to reset the service light on the Lexus RX-330
How to reset the service light on the Lexus RX-330
Lexus RX (2003-2008 / Xu30, MK 2) Today we will explain how to reset the service light of the Lexus RX model produced from 2003 to 2008. This operation is very simple and quick but sh…
How to reset the tire pressure warning light on the Lexus RX
How to reset the tire pressure warning light on the Lexus RX
Lexus RX (2016-2022 / MK 4, Al20) The following steps will show us how to reset the tire pressure warning on the Lexus RX; before resetting the TPMS sensors, it is necessary that all …

Other guides you may be interested in

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos