Do it yourself
| ||||
|
Mercedes Classe S - Video tutorial
Model: Mercedes Classe S
MK 3, W140
- Years 1991-1998 All engines are equipped with a so-called stick that allows you to check the state of the engine oil level. At the end of the stick there is in fact a level indicator between MIN (minimum) and Max (maximum) and it is absolutely important that the level is always included between these two limits, never below or above. To check the level, simply extract the stick, clean the end, insert it again as far as it will go and extract it to check to what extent it is soiled by the oil. It is preferable to carry out this check cold, since it is certain that there is no oil still in circulation and that everything has been deposited in the special cup; when the engine is hot, it is absolutely necessary to wait about 10-15 minutes to allow all the oil in circulation to flow into the sump. Approximately one liter of oil is included between the minimum and maximum level.
Posted on 8 August 2023 by ScegliAuto
Engine oil and engine oil filter replacement
Mercedes Classe S (1999-2005 / MK 4, W220) Raise the car on a lift or use a jack and apply car stands in correspondence with the special supports (rectangular plugs) present under the car chas
Engine oil and fillter replacement
Mercedes Classe S (1991-1998 / MK 3, W140) Once the car has been raised on the bridge, unscrew the drain plug from the oil pan which is located at the rear left corner (looking from the front)
How do you replace the oil pump on the Mercedes S-Class?
Mercedes Classe S (1999-2005 / MK 4, W220) In order to replace the oil pump of the Mercedes S-Class, you have to go and lift the car, so that you can unscrew the screws that fix the oil pan in Other guides that may interest you
|
Frequently Asked QuestionsHow to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.063
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |