Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe S
    4. : Engine oil and fillter replacement

Mercedes Classe S - Video tutorial

Model: Mercedes Classe S MK 3, W140 - Years 1991-1998
Part: Oil filter
Operation: Engine oil and fillter replacement

Once the car has been raised on the bridge, unscrew the drain plug from the oil pan which is located at the rear left corner (looking from the front); once the drain is complete, screw the cap back on. Then access the engine compartment and intercept the oil filter container: it is located in the rear part, immediately behind the tappet cover; the cap is in aluminum and fixed with three pins; then unscrew the fixing pins of the cap and extract the cartridge filter; then insert the filter egg and fix the cap after replacing the o-ring gasket and the copper washers. Finally, fill the engine with new oil up to the maximum level.


Posted on 2 August 2023 by ScegliAuto



Engine oil and engine oil filter replacement
Mercedes Classe S (1999-2005 / MK 4, W220) Raise the car on a lift or use a jack and apply car stands in correspondence with the special supports (rectangular plugs) present under the car chas
Engine oil level check instructions
Mercedes Classe S (1991-1998 / MK 3, W140) All engines are equipped with a so-called stick that allows you to check the state of the engine oil level. At the end of the stick there is in fact
How do you replace the oil pump on the Mercedes S-Class?
Mercedes Classe S (1999-2005 / MK 4, W220) In order to replace the oil pump of the Mercedes S-Class, you have to go and lift the car, so that you can unscrew the screws that fix the oil pan in

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos