Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe C
    4. : How to disassemble the wiper water pump of the Mercedes C-Class

Mercedes Classe C - Video tutorial

Model: Mercedes Classe C W204 - Years 2007-2013
Part: Windscreen wipers
Operation: How to disassemble the wiper water pump of the Mercedes C-Class

The guide shows how to replace the Mercedes Benz C-Class windshield wiper pump. To do this, you need to access the front left wheel compartment. Once the wheel arch has been removed, the glass water tank can be identified at the bottom; open the filler cap of the tank to help the water flow out. The pump is located on the bottom of the tank on the right. To detach it, simply rotate it until it comes out of its seat; pay attention to water leaking from the feed hole. Disconnect the electric connector only after all the water has flowed out. Reassemble the pump and fill the water tank to check the correct operation of the pump.


Posted on 22 August 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Classe C 2014-2021 - What to do when the windshield wiper of the Mercedes C-Class is not working? Read Answer
    • Classe C 2014-2021 - What is the windshield fuse on Mercedes C-Class? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos