Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 406
    4. : Rear wheel bearing replacement

Peugeot 406 - Video tutorial

Model: Peugeot 406 MK 1 - Years 1995-2005
Part: Bearing
Operation: Rear wheel bearing replacement

Lift the car in correspondence with the wheel on which to carry out the repair and apply a car stand, then disassemble the wheel, the brake caliper by removing the relative pads. Unscrew the fixing pins of the brake disc and remove it from the hub and unscrew the central fixing nut of the hub itself: therefore use the special spider extractor to extract the hub from the rear axle which must be carefully cleaned and lubricated. Then insert the new hub complete with bearing and tap it in the center so that the nut can be screwed on, which must therefore be properly tightened: dent the edge of the nut with a chisel and apply the cap. Then reassemble the brake disc (after applying grease to the center of the hub to prevent rust formation), the caliper, the pads and finally the wheel.


Posted on 29 June 2023 by ScegliAuto

How to open the Honda Sh 125 saddle when the battery is low

Let's see below how to proceed to raise and unlock the motorcycle seat when the battery is low, also helping us with the video. A square key is supplied with the scooter which is needed to unlock the saddle opening. This plastic key must be inserted into the seat inside the flap on the right side of the body immediately under the ignition switch. Then, open the plastic door and insert the key to unlock the saddle opening where we can find the battery and replace it if necessary.

Watch the video!


by ScegliAuto

More videos