Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Check Fluid Levels on a Peugeot Partner II

Model: Peugeot Partner Tepee B9 - Years: 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018
Part: Checks and maintenance

See other generations:
Video tutorial

Let's see how to check the fluid levels on a Peugeot Partner II: as a prerequisite, always perform these operations with the engine cold and on level ground. Start with the engine oil, for which you need to locate the dipstick, remove it, and wipe it with a cloth.

Reinsert it and then pull it out again, checking the level. If it is low, add a little oil at a time from the filler cap, checking frequently with the dipstick.

The level must never exceed "max". Next, check the expansion tank for the coolant: here too, the level should be between "min" and "max". If it is low, add the same colour fluid present in the expansion tank until it reaches the maximum level. The brake fluid is located on the side of the engine bay, driver's side near the windscreen, and theoretically should not drop.

If it is near the minimum level, it means the brake pads are worn. Add fluid but plan for their replacement.

Also, check the windscreen washer fluid, adding until it reaches the maximum level. Never add tap water as it could damage the pipes and the windscreen.


Posted on 14 June 2026 by ScegliAuto


Related tutorials

How to Check the AdBlue Level in a Peugeot Partner
How to Check the AdBlue Level in a Peugeot Partner
Peugeot Partner Tepee (2018-2026 / MK 3) The AdBlue warning light has not yet come on, but you want to be proactive and purchase the fluid in advance for a top-up? With the help of this shor…
How to Remove the Door Panel of a Peugeot Partner
How to Remove the Door Panel of a Peugeot Partner
Peugeot Partner Tepee (2008-2018 / B9) Before you start, open the front door of your Peugeot Partner. Begin by disengaging and removing the main insert of the door panel, using a thin but …
How do you reset the Service light on the Peugeot Partner?
How do you reset the Service light on the Peugeot Partner?
Peugeot Partner Tepee (2008-2018 / B9) To reset the Service light on the Peugeot Partner, you will need to hold down the button on the right side of the instrument panel while it is turned…

Other guides you may be interested in

    Frequently Asked Questions

    • Partner Tepee 2008-2018 - Where is the Peugeot Partner jack located? Read answer

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos