Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 206
    4. : Distribution kit replacement

Peugeot 206 - Video tutorial

Model: Peugeot 206 MK 1 - Years 1998-2012
Part: Timing belt
Operation: Distribution kit replacement

The distribution of an engine refers to all those mechanical parts that govern the injection phase and the exhaust phase of the gases in synchronization with the rotation of the crankshaft and therefore the movement of the pistons. To change the distribution kit it is necessary to lift the car and remove the wheel. To access the timing belt it is necessary to disassemble the accessory belt and synchronize the references, detach the tensioning rollers and thus remove the belt. Remove the water pump inside the distribution system and then move on to the assembly of the new distribution kit.


Posted on 28 July 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 206 1998-2012 - At how many km to change the timing belt in the Peugeot 206? Read Answer
    • 206 1998-2012 - How much does the timing belt cost on a Peugeot 206 1.4 hdi? Read Answer
    • 206 1998-2012 - How much does the Peugeot 206 14 HDi distribution kit cost? Read Answer
    • 206 1998-2012 - How much does it cost to replace the timing belt on the Peugeot 206 1.4 hdi? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos