Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 2008
    4. : How to replace the cabin air filter in a Peugeot 2008

Peugeot 2008 - Video tutorial

Model: Peugeot 2008 MK 1 - Years 2013-2019
Part: Cabin air filter
Operation: How to replace the cabin air filter in a Peugeot 2008

In this video tutorial we are shown the steps to be able to replace the passenger compartment air filter in a Peugeot 2008. First of all we will have to open the hood and identify the air filter to be replaced; as we are shown, the same is located under the plastic protection present on the front windshield under the wiper rods. To extract the filter, it will be necessary to unhook the three catches and remove the plastic cover. At this point we will have reached the filter and to be able to extract it we must first remove its protective cover. Now we can proceed with the replacement by inserting the new filter inside the special container and closing it with its plastic protection. Finally, we will have to reposition the protective grille on the windshield.


Posted on 23 May 2022 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Peugeot 2008 2019-2026 - Where is the cabin air filter located in the Peugeot 2008? Read Answer
    • Peugeot 2008 2013-2019 - Where is the pollen filter located on Peugeot 2008? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos