Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 207
    4. : Replacement of the clutch of the Peugeot 207 1.6.

Peugeot 207 - Video tutorial

Model: Peugeot 207 MK 1 - Years 2006-2015
Part: Clutch
Operation: Replacement of the clutch of the Peugeot 207 1.6.

Below we will see the instructions that will allow us to disassemble and replace the clutch discs of the Peugeot 207 1.6. First, we lift the car and start by removing the right front wheel; then we remove the fender and remove the V-belt, as shown in the video. At this point, we proceed with the disassembly of the front half shaft, unscrewing the fixing screws; we disconnect the starter motor to access the gearbox, then remove the engine support. We proceed with the removal of the gearbox and the subsequent replacement of the clutch kit, following the video tutorial until the end!


Posted on 3 October 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • 207 2006-2015 - How much is the clutch of the Peugeot 207? Read Answer
    • 207 2006-2015 - How much does it cost to change the clutch on the Peugeot 207? Read Answer
    • 207 2006-2015 - How much does it cost to redo the clutch on the Peugeot 207? Read Answer
    • 207 2006-2015 - How much does the Peugeot 207 1.4 petrol clutch cost? Read Answer
    • 207 2006-2015 - How much does it cost to replace the clutch of a Peugeot 207? Read Answer
    • 207 2006-2015 - How much is the clutch of the Peugeot 207? Read Answer
    • 207 2006-2015 - How much do you spend to redo the clutch on the Peugeot 207? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos