Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Renault
  4. :
  5. Scenic
  6. : Replacement of front shock absorbers

Renault Scenic - Video tutorial

Model: Renault Scenic MK III, MK 3, Scenic III, Scenic 3 - Years 2009-2015
Part: Shock absorbers
Operation: Replacement of front shock absorbers

It should be noted from the outset that to replace the front shock absorbers it is necessary to use the appropriate clamps to compact the relative spring; having said this, lift the car on the bridge and remove the front wheel, remove the support bracket of the brake oil pipe and move on to the disassembly of the bolts fixing the shock absorber to the hub; then access the engine compartment, remove the plastic grille immediately under the windscreen by removing the wiper blades, the brake fluid reservoir and the brush drive motor complete with the relative support bracket; at this point it is possible to access the bodywork dome and remove the fixing nuts of the shock absorber support; once the shock absorber has been removed, apply the clamps to the spring to be able to squeeze it enough and remove the support from the stem; then insert the spring in the new shock absorber together with the bellows and mount the support; then proceed backwards for installation on board the car, reassembling everything.


Posted on 2 September 2023 by ScegliAuto



Replacement of the shock absorbers of our car
Renault Scenic (1996-2003 / ) In the event that our car has exceeded 100,000 km, the shock absorbers must be replaced. The latter, in fact, have the function of cushioning the jol
Rear shock absorber replacement
Renault Scenic (1996-2003 / ) The replacement of the rear shock absorbers is much easier to carry out than the front ones since the spring and the shock absorber are separate and
How to replace the shock absorbers of the Renault Scenic
Renault Scenic (2009-2015 / MK III, MK 3, Scenic III, Scenic 3) Do you want to change the shock absorbers and do not know how to do it? In this video we will show you how to change them without difficulty. First y

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos