Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Scenic
    4. : Replacement of front shock absorbers

Renault Scenic - Video tutorial

Model: Renault Scenic MK 2, Scenic 2 - Years 2003-2009
Part: Shock absorbers
Operation: Replacement of front shock absorbers

The need to equip oneself with special clamps to squeeze the springs just enough to extract the damper is immediately pointed out; having said this, lift the car on the bridge and remove the front wheel, disconnect the cable glands and the connecting rod from the shock absorber; extract the head of the steering box tie rod from the hub support, unscrew the shock absorber fixing pins and release it from the same support; lower the car and access the engine compartment, remove the plastic covering grille located under the windscreen, also removing the wiper blades and the relative drive mechanism; at this point unscrew the fixing nuts of the shock absorber support and extract it from its seat; squeeze the spring and remove the support from the stem; apply the bellows, the spring and the support to the new shock absorber and proceed backwards to install them on board the car.


Posted on 8 September 2023 by ScegliAuto



Replacement of front shock absorbers
Renault Scenic (2009-2015 / MK III, MK 3, Scenic III, Scenic 3) It should be noted from the outset that to replace the front shock absorbers it is necessary to use the appropriate clamps to compact the relative sp
Replacement of the shock absorbers of our car
Renault Scenic (1996-2003 / ) In the event that our car has exceeded 100,000 km, the shock absorbers must be replaced. The latter, in fact, have the function of cushioning the jol
Rear shock absorber replacement
Renault Scenic (1996-2003 / ) The replacement of the rear shock absorbers is much easier to carry out than the front ones since the spring and the shock absorber are separate and

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos