Do it yourself
Frequently asked questions about cars and motorcycles

Removing Window Regulator Motor on Toyota Yaris

Model: Toyota Yaris Xp10 - Years: 1999, 2000, 2001, 2002, 2003, 2004, 2005
Part: Power window motor

See other generations:
Video tutorial

Remove the battery terminals. Using a screwdriver, unscrew the screws in the internal door handle and the screws in the opening lever area.

Once removed, take out the window switch panel. Detach the door panel, disconnect the speaker connectors, peel off the adhesive cover from the metal, and unscrew the window regulator motor with a screwdriver.

Remove the rail and motor from inside the door. Install a new motor and the glass rail.

Screw in the securing screws, refit the cover panel, and finally test the operation.


Updated on 16 March 2026 by ScegliAuto


Related tutorials

Toyota Yaris (2005-2011 / Xp90) Remove the window regulator mechanism from a Toyota Yaris? First, remove the door panel. Use a screwdriver to unscrew the fixing screws on the panel.…
Toyota Yaris (1999-2005 / Xp10) To replace the front window regulator motor on a Toyota Yaris, start by keeping the side window closed using a screwdriver, then remove the door pane…
Toyota Yaris (1999-2005 / Xp10) In this tutorial, see how to remove the window regulator motor in the first series Toyota Yaris, an operation to perform in case of failure. For the …
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

Other guides you may be interested in

How to adjust the headlights in the Toyota RAV4?

In this tutorial, you can see how to adjust the headlights in the Toyota RAV4, a very simple and quick operation. First, position the vehicle in front of a wall, about 40 centimetres away, then switch on the headlights and open the bonnet. Next, locate the small hole on both headlamps, apply tape on the wall at the same height, and using the indicated adjustment ring, position the beam of light so that it is perpendicular to the tape. Finally, move the vehicle back and check that the beam falls below the tape; if not, lower it slightly.

Watch the video!


by ScegliAuto

More videos