Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Toyota
    3. :
  3. Corolla
    4. : Removing the clutch master cylinder cylinder on Toyota Corolla VVT.I

Toyota Corolla - Video tutorial

Model: Toyota Corolla MK 2 - Years 2000-2007
Part: Pump
Operation: Removing the clutch master cylinder cylinder on Toyota Corolla VVT.I

Let's see the instructions to be able to remove the clutch pump or cylinder on a VVT-I motorized Toyota Corolla, in this case with the gearbox removed from the car. First of all, let's find our pump or the pressure plate of our clutch; then with a wrench we go to unscrew the screw of the liquid pipe and unscrew the screw of the bracket, as shown in the video. At this point we can remove our clutch pumping cylinder and replace it with the new one: we just have to follow the video to the end for reassembling the new component!


Posted on 17 January 2024 by ScegliAuto



Toyota Corolla VVT-i 16V timing chain replacement
Toyota Corolla (1995-2002 / MK 1) In today's video we will see the main instructions to be able to disassemble and replace the timing chain on a Toyota Corolla VVT-i 16 valve. First o
Guide to disassembling the VVT-i timing chain of the Toyota Corolla.
Toyota Corolla (2000-2007 / MK 2) In this short guide, we will see the main steps that will allow us to disassemble and replace the timing chain of the Toyota Corolla. To access the t
How do you remove the exterior handle of the Toyota Corolla?
Toyota Corolla (2013-2019 / MK 4, E160, E170) In order to remove the external handle of the Toyota Corolla, you need to open the corresponding door so that you can access the screw located on its

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos