Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Oil and Oil Filter Change on Toyota Corolla

Model: Toyota Corolla MK 2 - Years: 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007
Part: Engine oil

See other generations:
Video tutorial

Warm up the engine for a few minutes before changing the oil. Lift the car and position a container under the engine oil drain bolt, then loosen it with a 14 mm spanner and collect the used lubricant. Use the specific oil filter tool shown in this video to unscrew the old filter while the oil drains into the container.

Replace it by inserting and tightening the new filter. Once all the oil has drained, re-tighten the bolt that seals the drain hole and measure the amount of lubricant that has come out. Now refill the same amount through the upper hole.


Updated on 18 April 2026 by ScegliAuto


Related tutorials

How to Replace the Engine Oil and Oil Filter on the Toyota Corolla VVT-I
How to Replace the Engine Oil and Oil Filter on the Toyota Corolla VVT-I
Toyota Corolla (2000-2007 / MK 2) Today's DIY steps will show you how to carry out the routine maintenance service by replacing the engine oil and oil filter on the Toyota Corolla VVT…
How to Replace the Engine Oil and Oil Filter on the Toyota Corolla MK4
How to Replace the Engine Oil and Oil Filter on the Toyota Corolla MK4
Toyota Corolla (2013-2019 / E160, E170, MK 4) In this video tutorial, we will see the main steps to perform routine maintenance by changing the oil on the fourth-generation Toyota Corolla, in sim…
How to Change the Oil in a Toyota Corolla
How to Change the Oil in a Toyota Corolla
Toyota Corolla (2006-2013 / MK 3) To change the oil in your Toyota Corolla, the steps are very simple. First, raise the car on ramps to access the underside. Next, locate the oil sump…

Other guides you may be interested in

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos