Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Engine Oil and Oil Filter on the Toyota Corolla VVT-I

Model: Toyota Corolla MK 2 - Years: 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007
Part: Engine oil

See other generations:
Video tutorial

Today's DIY steps will show you how to carry out the routine maintenance service by replacing the engine oil and oil filter on the Toyota Corolla VVT-I. First, lift the vehicle and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge located next to the sump, using the appropriate tool, as shown in the video.

At this point, install the new oil filter and finally pour in the suitable oil, filling up to the maximum level mark.


Updated on 6 September 2026 by ScegliAuto


Related tutorials

How to Replace the Engine Oil and Oil Filter on the Toyota Corolla MK4
How to Replace the Engine Oil and Oil Filter on the Toyota Corolla MK4
Toyota Corolla (2013-2019 / E160, E170, MK 4) In this video tutorial, we will see the main steps to perform routine maintenance by changing the oil on the fourth-generation Toyota Corolla, in sim…
Replacing the Serpentine Belt on the Toyota Corolla 1.8 VVT-I
Replacing the Serpentine Belt on the Toyota Corolla 1.8 VVT-I
Toyota Corolla (2006-2013 / MK 3) In today's video, you will see how to remove and replace the serpentine belt on the Toyota Corolla 1.8 VVT-I by following these simple steps. First, …
Removing the Injectors from the Toyota Corolla VVT-I
Removing the Injectors from the Toyota Corolla VVT-I
Toyota Corolla (2000-2007 / MK 2) Today, discover the steps to remove and replace the injectors of the Toyota Corolla VVT-I by following the instructions below. First, open the bonnet…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos