Do it yourself
Frequently asked questions about cars and motorcycles

How to Remove the Radio from the Toyota 4Runner

Model: Toyota 4runner N280 - Years 2010-2024
Part: Car stereo

Before discovering how to properly remove the radio from the Toyota 4Runner, ensure that the vehicle's engine is off and the battery is disconnected. This eliminates any risk from electrical current or potential overheating. Next, remove the two plastic side covers by pulling them towards you. Do the same with the entire air conditioning control panel, using a flat screwdriver (or similar tools) for assistance. Disconnect the electrical pin present. Now take a 10 mm wrench and remove the screws that hold the entire radio in place. Once done, pull the entire component towards you and disconnect it from the connector, then connect the new radio to this connector. Reinstall the screws you previously removed and reposition all the various components you took off earlier. Finally, reconnect the vehicle's battery.

Updated on 6 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Toyota 4runner (2002-2009 / N210) In this short video, you will learn how to remove and replace the original radio of the fourth generation Toyota 4Runner by following these simple st…
Toyota 4runner (2002-2009 / N210) Let's discover the procedure for removing and replacing the factory radio of the Toyota 4Runner N210 in simple and quick steps. First, get inside the…
Toyota 4runner (1996-2002 / N180) In today's video, learn how to replace the radio in a Toyota 4Runner. First, gather a new device to install in your vehicle. Next, detach the dashboa…

Other guides you may be interested in

    Frequently Asked Questions

    • 4runner 1996-2002 - Why does the Toyota 4Runner radio not turn on? Read answer

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos