Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Oil and Oil Filter on a Toyota Corolla

Model: Toyota Corolla MK 4, E170, E160 - Years 2013-2019
Part: Engine oil

To change the oil filter and engine oil, follow these steps: Start by raising the front of the car, open the bonnet and secure it. Remove the plastic engine cover from the top of the engine, unscrew the oil filler cap, and lift the dipstick. Go underneath the car and locate the oil sump, unscrew the oil drain plug, placing a container underneath to catch the oil. Once the oil has drained, clean the plug and refit it. Next to the sump plug, you will find the oil filter, which you will unscrew using a socket wrench, again placing a container underneath to catch any oil. Take the new oil filter out of its packaging, apply some oil to the seal of the new filter, and screw it back into place. Now, go back to the top and using a funnel, pour in the specified litres of oil. When you are close to the required amount, check the level using the dipstick (insert it, remove it, clean it, reinsert it, and check). If the level is not at the "max" mark, top it up; otherwise, the operation is complete. Lower the car and close the bonnet.

Updated on 7 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Toyota Corolla (2000-2007 / MK 2) Today's DIY steps will show you how to carry out the routine maintenance service by replacing the engine oil and oil filter on the Toyota Corolla VVT…
Toyota Corolla (2000-2007 / MK 2) Warm up the engine for a few minutes before changing the oil. Lift the car and position a container under the engine oil drain bolt, then loosen it w…
Toyota Corolla (2006-2013 / MK 3) To change the oil in your Toyota Corolla, the steps are very simple. First, raise the car on ramps to access the underside. Next, locate the oil sump…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos