Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Toyota
    3. :
  3. Rav 4
    4. : Where is the fuel pump relay located in the Toyota RAV4?

Toyota Rav 4 - Video tutorial

Model: Toyota Rav 4 Xa40, MK 4 - Years 2013-2018
Part: Fuel pump
Operation: Where is the fuel pump relay located in the Toyota RAV4?

If the fuel pump of our Toyota RAV4 has suddenly stopped working and the respective fuses are in good condition, we can then check the status of the relay whose position is indicated in this video. As shown, the relay in question is located in the box inside the engine compartment, protected by the black plastic cover right next to the battery. It is the last one in the second to last row, looking at the box from the front. If it is faulty, make sure to use a replacement with equivalent specifications and operate with the vehicle turned off, so as not to cause any damage.


Posted on 28 February 2024 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • Rav 4 2013-2018 - What is the position of the fuel pump on the Toyota Rav4? Read Answer
    • Rav 4 2019-2026 - I have problems with the fuel pump of my Toyota Rav 4, how much could it cost me? Read Answer
    • Rav 4 2000-2006 - Where is the Toyota RAV 4 float located? Read Answer
    • Rav 4 2000-2006 - How to remove the diesel pump of the 2003 Toyota Rav 4? Read Answer
    • Rav 4 2000-2006 - How much does it cost to repair the 2003 Toyota Rav4 diesel injection pump? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos