Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to solve the problem of insufficient engine oil pressure on a 1.3 multiJet

Model: (Various brands) Various
Part: Engine oil

In this video we can see what are the reasons for the insufficient oil pressure on a 1.3 MultiJet engine. When the red light comes on, we must stop and turn off the engine. In the specific case of the YouTuber, it was a problem with the dipstick, which was dirty. However, this is not always the problem. Other solutions may include: a valve inside the heat exchanger, the oil filter, or a fault in the oil pump that will need to be completely replaced. But let's go back to our specific case: we will need to safely lift the vehicle, then drain the oil pan, remove the gearbox bracket - to work more comfortably it would be necessary to remove the exhaust pipe - and then remove all the screws of the oil pan, which is also attached with a sealant, which we will have to separate with a thin blade. As we can see, the dipstick is very dirty, so the oil had trouble reaching the sensor. We take the opportunity to clean all the mechanical parts, including the pan inside. We clean the outer edges of the pan and put back the high-temperature silicone, joining the two halves and putting back all the screws. We put back the bolt with the gasket and fill with new oil. Job done.

Posted on 26 June 2024 by ScegliAuto

Video tutorial

Related tutorials

What to Do When the Tyre Pressure Light Comes On
What to Do When the Tyre Pressure Light Comes On
(Various brands) Various In this practical video tutorial, you will find possible advice on how to resolve the issue when the tyre pressure light comes on in your car. Firstl…
How Does the Oil Pressure Sensor Work?
How Does the Oil Pressure Sensor Work?
(Various brands) Various In this short video, the author explains in detail how an oil pressure sensor works. Firstly, it clarifies that it does not read the oil level, but t…
How to clean the oil pressure sensor
How to clean the oil pressure sensor
(Various brands) Various The oil pressure sensor, also known as the "oil pressure bulb", is used to monitor the oil pressure inside the engine and to alert the driver in case…

Other guides you may be interested in

    Frequently Asked Questions

    • Vari - How much oil is needed for the Harley-Davidson Fat Boy? Read answer
    • Vari - What does the "Oil Insp" message mean? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos