Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Volkswagen Bora - Shocks

Shocks Volkswagen Bora (1998-2005 / mk 6)

Volkswagen Bora (1998-2005 / MK 6)
Replacement of Rear Shock Absorbers
Replacing the rear shock absorbers is much simpler than the front ones since the springs are not attached to the shock absorber itself but are connected to the …Read all…
Posted on 20 February 2026 by ScegliAuto
Volkswagen Bora (1998-2005 / MK 6)
Front Shock Absorber Replacement
Lift the vehicle on a ramp and remove the front wheel and the nut securing the strut to the support inside the engine bay; disconnect the brake wear sensor …Read all…
Posted on 11 February 2026 by ScegliAuto
Alternator (1) Shocks (2) Antenna (2) Air conditioning (1) Battery (1) Ignition coil (2) Air vents (1) Control arm (1) Grille (1) Glow plugs (1) Control unit (1) Timing belt (2) Checks and maintenance (3) Bearing (1) Headlight (6) Air filter (1) Cabin air filter (2) Fuel filter (2) Diesel fuel filter (2) Accessory kit (1) Light bulb (1) Headlight bulb (1) Tail light bulb (2) Interior dome light bulb (1) Antifreeze coolant (2) Handle (1) Engine (1) Power window motor (1) Clock (1) Door trim panel (3) Front bumper (1) Brake pads (3) Pump (2) Car door (1) Push button (1) Power window switch (1) Radiator (1) Fuse box (10) Axle shaft (1) Engine coolant temperature sensor (1) Side mirror (2) Warning light – error code (1) Service warning light (2) Fuel cap (2) Windshield wipers (3) Thermostat (5) Center console tunnel (1) Valve (2) EGR valve (2) Blower motor (1) Side window (1)

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos