Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Volkswagen
  4. :
  5. Bora
  6. : Windshield wipers

Volkswagen Bora - Windshield wipers

Windshield Wipers Volkswagen Bora (1998-2005 / mk 6)

Volkswagen Bora (1998-2005 / MK 6)
Removing Engine Management Unit

The engine management unit is located just below the scuttle panel, in the centre. To remove it, first remove the plastic grille directly under the windscreen. …Read all…
Posted on 28 February 2026 by ScegliAuto
Volkswagen Bora (1998-2005 / MK 6)
Dismantling and Repairing Wiper Motor

The wiper motor is located just under the windscreen: to dismantle it, first remove the wiper arms. Then remove the seal from the edge of the plastic cover, …Read all…
Posted on 23 February 2026 by ScegliAuto
Volkswagen Bora (1998-2005 / MK 6)
Dismantling the Wiper Motor

Open the front bonnet and unscrew the fastening nuts of the wiper blades to remove them; then dismantle the plastic cover located just below the windscreen by …Read all…
Posted on 10 February 2026 by ScegliAuto

Alternator (1) Shocks (2) Antenna (2) Air conditioning (1) Battery (1) Ignition coil (2) Air vents (1) Control arm (1) Grille (1) Glow plugs (1) Control unit (1) Timing belt (2) Checks and maintenance (3) Bearing (1) Headlight (6) Air filter (1) Cabin air filter (2) Fuel filter (2) Diesel fuel filter (2) Accessory kit (1) Light bulb (1) Headlight bulb (1) Tail light bulb (2) Interior dome light bulb (1) Antifreeze coolant (2) Handle (1) Engine (1) Power window motor (1) Clock (1) Door trim panel (3) Front bumper (1) Brake pads (3) Pump (2) Car door (1) Push button (1) Power window switch (1) Radiator (1) Fuse box (13) Axle shaft (1) Engine coolant temperature sensor (1) Side mirror (2) Warning light – error code (1) Service warning light (4) Fuel cap (2) Windshield wipers (3) Thermostat (5) Center console tunnel (1) Valve (2) EGR valve (2) Blower motor (1) Side window (1)

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos