Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Bora
    4. : EGR valve

Volkswagen Bora - EGR valve

EGR Valve Volkswagen Bora (1998-2005 / mk 6)

Volkswagen Bora (1998-2005 / MK 6)
Instructions for Disassembling EGR Valve
It is advisable to carry out this maintenance with the engine cold. The EGR valve is located at the rear of the engine: the first step is to disconnect the …Read all…
Posted on 11 February 2026 by ScegliAuto
Volkswagen Bora (1998-2005 / MK 6)
Dismantling and Cleaning the EGR Valve
Many devices are used to reduce harmful emissions, including the EGR valve. The recycling of exhaust gases (in the context of internal combustion alternative …Read all…
Posted on 4 February 2026 by ScegliAuto
Alternator (1) Shocks (2) Antenna (2) Air conditioning (1) Battery (1) Ignition coil (2) Air vents (1) Control arm (1) Grille (1) Glow plugs (1) Control unit (1) Timing belt (2) Checks and maintenance (3) Bearing (1) Headlight (6) Air filter (1) Cabin air filter (2) Fuel filter (2) Diesel fuel filter (2) Accessory kit (1) Light bulb (1) Headlight bulb (1) Tail light bulb (2) Interior dome light bulb (1) Antifreeze coolant (2) Handle (1) Engine (1) Power window motor (1) Clock (1) Door trim panel (3) Front bumper (1) Brake pads (3) Pump (2) Car door (1) Push button (1) Power window switch (1) Radiator (1) Fuse box (10) Axle shaft (1) Engine coolant temperature sensor (1) Side mirror (2) Warning light – error code (1) Service warning light (2) Fuel cap (2) Windshield wipers (3) Thermostat (5) Center console tunnel (1) Valve (2) EGR valve (2) Blower motor (1) Side window (1)

How to Replace the External Wing Mirror on a Ford C MAX

In the event of a breakage, it will be necessary to replace the external wing mirror on the 2011 Ford C MAX. This operation is easily performed independently. Start by removing the internal cover of the mirror with a plastic lever. Then, use a socket wrench to remove the securing pins. Once the pins are removed, you can take off the mirror, but not before disconnecting the power connectors. Then proceed to fit the new mirror. First, connect the connectors and then secure the mirror to its housing with the pins. Refit the plastic cover and test the operation of the electric mirror using the controls.

Watch the video!


by ScegliAuto

More videos