Do it yourself
| ||||
|
Volkswagen Bora - Video tutorial
Model: Volkswagen Bora
MK 6
- Years 1998-2005 A first method to check the efficiency of the water pump is to check if coolant arrives from the return pipe connected to the expansion tank: before starting the engine, therefore, disconnect the return pipe from the expansion tank, paying attention be careful not to damage the plastic spout; once the tube has been extracted, start the engine by activating the passenger compartment heating in order to lower the circuit pressure and check for liquid leaking from the tube: if it does not come out even when accelerating, then the water pump must be replaced. In this case, the water pump is driven by the timing belt and to be able to replace it, it is necessary to disassemble everything: therefore, consider whether it is necessary to replace the entire distribution kit rather than just the pump (the impeller is in fact broken in plastic). Once everything has been installed and the refrigeration system filled, carry out the same check: if liquid comes out of the return pipe, everything is in order.
Posted on 13 August 2023 by ScegliAuto
Guide to replacing the water pump
Volkswagen Bora (1998-2005 / MK 6) Changing the water pump in your car is an operation that can be a little complicated but with a little commitment and good will you can do it. It is
How to replace the timing belt on Volkswagen Bora
Volkswagen Bora (1998-2005 / MK 6) Let's see how to replace the timing belt on a Volkswagen Bora (Jetta). Let's open the bonnet and lift it, let's secure it with the dipstick. Disconne
Coolant temperature sensor replacement.
Volkswagen Bora (1998-2005 / MK 6) Open the bonnet and disconnect the negative pole of the battery to work safely. The sensor is located on the engine block at the height of the water Other guides that may interest you
|
Frequently Asked QuestionsHow to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.035
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |