Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Check Brake Pedal Function

Model: Volkswagen Transporter MK 3, T3, T25 - Years: 1979, 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990
Part: Checks and maintenance

See other generations:
Video tutorial

If, with the engine running (so that the brake booster is also active), you lightly press the brake pedal and it tends to sink, while pressing it quickly results in a normal response, there are two possible causes: either there is air in the system, or there is a problem with the master cylinder of the brake pump.

The second hypothesis is much more likely, as holding the pedal lightly causes the fluid to leak through the seals of the pump, and the pedal sinks.

In any case, it is always best to start with bleeding the system to eliminate any air present, but if the problem persists even after bleeding, then you must address the master cylinder.


Updated on 20 February 2026 by ScegliAuto


Related tutorials

How to Reset the Service on the Volkswagen Transporter Van?
How to Reset the Service on the Volkswagen Transporter Van?
Volkswagen Transporter (2014-2025 / T6, MK 6) In this tutorial, you will see how to reset the service on the Volkswagen Transporter van, an extremely simple and quick operation that should only b…
Check Oil Pressure Sensor Functionality
Check Oil Pressure Sensor Functionality
Volkswagen Transporter (1979-1990 / MK 3, T3, T25) There are specific tools available to check the correct functioning of the engine oil pressure sensor (commonly known as the bulb): it is very import…
Replacing Brake Pads on Volkswagen Transporter
Replacing Brake Pads on Volkswagen Transporter
Volkswagen Transporter (2003-2014 / T5, MK 5) Removing worn brake pads? Let's remove the brake pads from the Volkswagen Transporter. Lift the Transporter with a jack or column lift, then remove t…

    Frequently Asked Questions

    • Transporter 2014-2025 - Where is the OBD port located on the Volkswagen Transporter? Read answer

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos