Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Guide to Removing the Fuel Pump from the Volkswagen Polo

Model: Volkswagen Polo 6R, MK V, Polo 5, Polo V, MK 5 - Years: 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017
Part: Fuel pump

See other generations:
Video tutorial

Today's guide will show you how to remove and replace the fuel pump in the Volkswagen Polo by following these simple steps. First, open the rear doors and start removing the rear seat; then remove the fuel pump cover and disconnect the inlet and outlet pipes, as shown in the video.

At this point, disconnect the electrical connector of the fuel level sensor, then unscrew the plastic ring to remove it; replace and install the new fuel pump by applying the reverse procedure!


Updated on 17 September 2026 by ScegliAuto


Related tutorials

How to Replace the Fuel Pump on a VW Polo
How to Replace the Fuel Pump on a VW Polo
Volkswagen Polo (2001-2009 / MK IV, Polo 4, 9N, MK 4, Polo IV) Learn how to replace the damaged fuel pump on a Polo. First, remove the rear seat cushions, then take off the cover cap of the fuel pump. Once the ca…
Where is the Fuel Pump Relay Located on a Volkswagen Polo?
Where is the Fuel Pump Relay Located on a Volkswagen Polo?
Volkswagen Polo (2001-2009 / MK IV, Polo 4, 9N, MK 4, Polo IV) The fuel pump relay on our Volkswagen Polo is located inside the lower area of the dashboard, beneath the steering column. To access it, start by unc…
How to Replace the Fuel Pump on a Volkswagen Polo?
How to Replace the Fuel Pump on a Volkswagen Polo?
Volkswagen Polo (2001-2009 / MK IV, Polo 4, 9N, MK 4, Polo IV) To replace the fuel pump on a Volkswagen Polo, first loosen the screws securing the rear seat bench to its housing. Once removed, you can locate the …

Other guides you may be interested in

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos