Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Passat
    4. : How to remove the trunk lining of a Volkswagen Passat Variant B7

Volkswagen Passat - Video tutorial

Model: Volkswagen Passat B7 - Years 2010-2014
Part: Bodywork
Operation: How to remove the trunk lining of a Volkswagen Passat Variant B7

In this video we see how to remove the trunk lining of a Volkswagen Passat Variant B7: we start by lifting the cover of the trunk floor, then we remove the plastic cover underneath, then we unscrew the two torx screws and remove the lower panel, which is held in place by four clips. Now we remove the parcel shelf, then we unscrew the two torx screws that remove the floor lining. We lift the lower part of the seat and unscrew the nut that secures the lower part of the side cushion. We will need to remove the upper plastic cover, lift and remove the cushion. From this side lining we remove the lower clip, two fastening clips and the upper clip inside the sealing ring. We will need to remove this single-use plastic rivet. Unfortunately the youtuber did not film how he removed the driver's seat, but there is a small cover under the handle where leverage should be applied. The best way to remove the main lining is to pull from the top, where the clips are located. We remove the release cables and disconnect the buttons by pressing the pin. We remove the pillar lining and that's it.


Posted on 27 April 2024 by ScegliAuto

How do you adjust the clutch cable on the Kia Picanto?

To be able to adjust the clutch cable of the Kia Picanto you need to open the hood so that you have access to the components inside the engine compartment: in order to reach the cable you will need to remove some components on the right side, such as the battery and the air filter. Below them you will find the clutch cable, which will have to be adjusted by screwing or loosening the bolt placed at the end of the cable. This will make the pedal harder or softer; after the adjustment, it will be possible to assemble all the components by closing the hood.

Watch the video!


by ScegliAuto

More videos