Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installing Bluetooth Accessory Kit

Model: Volvo S60 MK 1 - Years: 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009
Part: Accessory kit

See other generations:
Video tutorial

Using a plastic tool to avoid damaging the body, pry on the side clips of the climate control panel to remove it and access the retaining screws of the radio console. Be careful not to disconnect the green connectors.

Remove the plastic trim around the radio by prying at the edges. Unscrew the retaining screws of the console and completely remove it. Disconnect the necessary electrical wiring connectors to install the kit. Prepare the cables included with the Bluetooth kit, inserting them into the original connectors and connecting the other end to the kit's control unit.

Wire the kit according to the attached instructions and secure it inside the dashboard or on the passenger side. Reinstall the cover, routing the cables through the radio tunnel.

Reinstall the climate control panel by reversing the previous steps. Turn on the radio and check the proper functioning of all the new features offered.


Updated on 4 February 2026 by ScegliAuto


Related tutorials

Removing Car Radio and Installing iPod Accessory Kit
Volvo S60 (2000-2009 / MK 1) Position the gear lever in D (drive) and use a plastic lever to detach the plastic trim under the gear lever from the back and pull it forward (befor…
Muffler Replacement Instructions
Muffler Replacement Instructions
Volvo S60 (2000-2009 / MK 1) Perform this repair with the vehicle cold. Lift the car on a hydraulic lift and remove the muffler starting from the flange located after the exhaust…
How to replace the serpentine belt on the Volvo S60?
How to replace the serpentine belt on the Volvo S60?
Volvo S60 (2010-2018 / MK 2) To replace the serpentine belt on the Volvo S60, lift the car with a jack or a lift so you can loosen the bolts securing the front right wheel. Once …

Other guides you may be interested in

How to open the bonnet on a Volkswagen Golf?

In this tutorial, you will see how to open the bonnet on a Volkswagen Golf MK4. This is a very simple operation that follows the standard procedure. First, open the driver's door, then locate the lever in the lower left area and pull it. Next, move to the front of the vehicle, lift the bonnet slightly, and find the second lever located just above the Volkswagen logo. At this point, simply pull it towards you, fully open the bonnet, and secure it with the prop rod. To close it, gently push it down.

Watch the video!


by ScegliAuto

More videos