|
Do it yourself
| |||
| ||||
Removing and Replacing the ABS Control Unit
Model: Volvo S80
- Years 1998-2006
First disconnect the negative terminal of the battery located in the rear boot, under the mat, on the left rear side (you need to remove the upper fastening plate).
The ABS control unit is located just below the fuse box in the engine compartment. Open the front bonnet and remove the air filter housing by disconnecting the hose connected to the intake manifold, the intake duct near the radiator, and the connector of the mass air flow sensor: the air filter housing comes out simply by pulling it upwards. Then disconnect the connector attached to the ABS control unit by pulling the securing clip outwards and unscrew the 4 fastening bolts of the unit from the pump, being careful not to drop them into the engine compartment. At this point, remove the old control unit and install the new one by tightening the respective fastening bolts and reconnecting the plug to the terminal block (it simply clicks into place with the securing clip). Finally, remount the air filter housing. Reconnect the battery terminal, turn on the ignition and ensure that the ABS warning light on the dashboard is off.
Updated on 4 February 2026 by ScegliAuto
Video tutorial
Related tutorials
Volvo S80
(1998-2006 /
)
To access the ABS pump control unit, you need to remove the air filter housing.
Disconnect the connector attached to the mass air flow sensor located…
Volvo S80
(1998-2006 /
)
Before proceeding with the removal of the steering wheel, it is advisable to disconnect the negative terminal of the battery to avoid warning lights …
Volvo S80
(1998-2006 /
)
When the alternator fails, the battery charge warning light illuminates on the dashboard: you must replace it as soon as possible since the remaining…
Other guides you may be interested in
|
How to Open the Bonnet of a Renault Megane if the Lever is Broken?
If the lever that unlocks the bonnet of the Renault Megane is broken or not functioning, there is an emergency procedure to unlock the mechanism: remove the right front grille located at the top of the bumper. Once the grille is removed, you can locate the actuator mechanism: by pulling the spring in this position, you can unlock the actuator, allowing you to lift the bonnet and access the components located inside the engine compartment. You can then close the bonnet simply by lowering it. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.278
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |