Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Audi
  4. :
  5. A6
  6. : Air conditioning

Audi A6 - Air conditioning

Audi A6 (2004-2012 / C6, MK 3)
Replace the pressure switch that controls the air conditioning compressor on the Audi A6.

How to replace the air conditioning pressure switch that causes the fan motor to malfunction on an Audi A6. We need to open the hood and remove the plastic …read all…
Posted on 29 May 2023 by ScegliAuto
Audi A6 (1997-2004 / MK 2, C5)
How to change the air conditioning compressor of the Audi A6 3.2L

Let's see in this guide, the main instructions to be able to disassemble and replace the air conditioning compressor of the Audi A6 3.2L. First of all we raise …read all…
Posted on 9 July 2022 by ScegliAuto
Audi A6 (2004-2012 / C6, MK 3)
Instructions for removing the climate control controls

The climate control controls are located in the center of the console, immediately below the ventilation vents and are fixed to the interlocking dashboard, so …read all…
Posted on 12 September 2023 by ScegliAuto
Audi A6 (2004-2012 / C6, MK 3)
Internal heating valve replacement

The regulation of the coolant flow inside the passenger compartment heating radiator is managed by means of electro valves controlled by the automatic climate …read all…
Posted on 22 August 2023 by ScegliAuto
Audi A6 (2004-2012 / C6, MK 3)
Air conditioning compressor replacement

To carry out this repair, it is advisable to contact a garage that has the appropriate appliance to recover the gas, before disassembly, and that after …read all…
Posted on 12 August 2023 by ScegliAuto

Airbags (2) Alternator (3) Loudspeaker (1) Antenna (2) Air conditioning (5) Car stereo (5) Battery (5) Coil (1) Air Vents (6) Bushings (2) Arm (7) Gearbox (2) Spark plugs (2) Bodywork (2) Glove box (3) Control unit (3) Key (26) Timing belt (9) V-belt (5) Air conditioning (1) Air conditioning controls (1) -board computer (15) Checks and maintenance (33) Throttle body (3) Dashboard (2) Gearshift gaiter (2) Drive shaft boot (1) Bearing (1) Brake discs (5) Headlight (8) Tail light (4) Particulate filter (1) Air filter (10) Cabin air filter (12) Petrol filter (1) Diesel filter (3) Oil filter (2) Hand brake (1) Injectors (1) Window lift switch (3) Accessory Kit (2) Xenon headlight kit (2) Light bulb (7) Side turn signal light bulb (2) Headlight bulb (8) Rear light bulb (5) Interior lights ceiling light bulb (2) Third brake light (1) Handle (3) Mask (1) Engine (8) Window motor (1) Gear oil (1) Engine oil (4) Door panel (11) Front bumper (3) Rear bumper (1) Brake pads (6) Hydraulic pistons (1) Tires (5) Gear Shift Knob (3) Pump (3) Fuel pump (8) Door (2) Push button (4) Window lift button (1) Instrument cluster (10) Radiator (1) Passenger compartment heating radiator (3) Wheel (3) Fuse box (18) Seat (2) Drive shaft (1) Coolant temperature sensor (1) Lock (5) Brake system (1) Lambda sensor (1) Outside rearview mirror (7) Engine mount (2) Windscreen wipers (3) Thermostat (3) Central tunnel (1) Turbine (3) Valve (1) EGR valve (1)

How to reset the oil change light on Kymco Agility 125

If we have done the oil change on this type of scooter in do-it-yourself mode, we need to complete the job by resetting the oil change light that came on in the instrument panel display. In the description below we can find the necessary steps to do this. First you need to insert the key on the ignition switch and turn on the ignition. Then show the total mileage on the display and then press the two buttons at the bottom of the panel at the same time until the oil change light goes off.

Watch the video!


by ScegliAuto

More videos