Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Audi
  4. :
  5. A6
  6. : Bushings

Audi A6 - Bushings

Audi A6 (1994-1997 / MK 1, C4)
How to replace the rear arm bushing.

First of all, put the car on the bridge and raise it to a comfortable height to work on it. Remove the rear wheel corresponding to the bush to be replaced. …read all…
Posted on 16 September 2023 by ScegliAuto
Audi A6 (1994-1997 / MK 1, C4)
Replacement of anti-roll bar bushing

The failure of the anti-roll bar bushings is a very recurring defect on various car models since they are found to absorb really significant stresses that lead …read all…
Posted on 13 September 2023 by ScegliAuto

Airbags (2) Alternator (3) Loudspeaker (1) Antenna (2) Air conditioning (5) Car stereo (5) Battery (5) Coil (1) Air Vents (6) Bushings (2) Arm (7) Gearbox (2) Spark plugs (2) Bodywork (2) Glove box (3) Control unit (3) Key (26) Timing belt (9) V-belt (5) Air conditioning (1) Air conditioning controls (1) -board computer (15) Checks and maintenance (33) Throttle body (3) Dashboard (2) Gearshift gaiter (2) Drive shaft boot (1) Bearing (1) Brake discs (5) Headlight (8) Tail light (4) Particulate filter (1) Air filter (10) Cabin air filter (12) Petrol filter (1) Diesel filter (3) Oil filter (2) Hand brake (1) Injectors (1) Window lift switch (3) Accessory Kit (2) Xenon headlight kit (2) Light bulb (7) Side turn signal light bulb (2) Headlight bulb (8) Rear light bulb (5) Interior lights ceiling light bulb (2) Third brake light (1) Handle (3) Mask (1) Engine (8) Window motor (1) Gear oil (1) Engine oil (4) Door panel (11) Front bumper (3) Rear bumper (1) Brake pads (6) Hydraulic pistons (1) Tires (5) Gear Shift Knob (3) Pump (3) Fuel pump (8) Door (2) Push button (4) Window lift button (1) Instrument cluster (10) Radiator (1) Passenger compartment heating radiator (3) Wheel (3) Fuse box (18) Seat (2) Drive shaft (1) Coolant temperature sensor (1) Lock (5) Brake system (1) Lambda sensor (1) Outside rearview mirror (7) Engine mount (2) Windscreen wipers (3) Thermostat (3) Central tunnel (1) Turbine (3) Valve (1) EGR valve (1)

How to reset the oil change light on Kymco Agility 125

If we have done the oil change on this type of scooter in do-it-yourself mode, we need to complete the job by resetting the oil change light that came on in the instrument panel display. In the description below we can find the necessary steps to do this. First you need to insert the key on the ignition switch and turn on the ignition. Then show the total mileage on the display and then press the two buttons at the bottom of the panel at the same time until the oil change light goes off.

Watch the video!


by ScegliAuto

More videos