Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : How to remove the fuel pump of a BMW 3 Series

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E36 - Years 1990-2001
Part: Fuel pump
Operation: How to remove the fuel pump of a BMW 3 Series

In this video guide we see how to disassemble the fuel pump of a BMW 3 Series. To begin, we disconnect the battery cables, then, we remove the rear seats of the car. We will find the wiring and a metal piece with screws, which we need to disassemble. Unscrew the tightening screws of the metal cap with a socket wrench, remove it from its seat. We wrap the entire perimeter of the sheet with absorbent paper; with a chisel we unscrew the large locking pin (if present). Finally we disconnect the power supply terminals and the liquid circulation tubes. We take out the fuel pump.


Posted on 22 November 2023 by ScegliAuto

This video is currently unavailable

Other guides that may interest you

    Frequently Asked Questions

    • Serie 3 2005-2013 - Why is the BMW 320d diesel pump not working? Read Answer
    • Serie 3 1998-2006 - How to solve the problem with the fuel pump in the BMW 3 Series? Read Answer
    • Serie 3 1998-2006 - Where is the fuel pump of a BMW 3 Series located? Read Answer
    • Serie 3 1998-2006 - Where is the diesel pump of the BMW 3 Series E46? Read Answer
    • Serie 3 1998-2006 - Where is the diesel pump of the BMW 320d E46? Read Answer
    • Serie 3 2005-2013 - Where is the fuel pump of the BMW 320 located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos