Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Guide to disassembling the engine on the BMW 1 Series F20 M135i

Model: BMW Serie 1 MK 2, F21, F20 - Years 2011-2019
Part: Engine

In this video tutorial we will see the main instructions for disassembling and removing the engine on the BMW 1 Series F20, in the M135i version. First we open the bonnet and start by removing the front bumper; then we go to disassemble the intercooler and radiator, disconnecting the coolant hose. At this point we disconnect the engine transmission and all the various wiring, including the pipes; we remove the front half-shafts and unscrew the bolts of the engine mounts. We just have to remove the whole engine block, following the video tutorial to the end!

Posted on 16 April 2022 by ScegliAuto

Video tutorial

Related tutorials

Where is the OBD port located on the BMW 1 Series F20?
Where is the OBD port located on the BMW 1 Series F20?
BMW Serie 1 (2011-2019 / MK 2, F21, F20) If you own a BMW 1 Series f20 and want to find out where the OBD port is located so you can connect any compatible diagnostic tool, all you have to d…
How to replace the remote control battery of BMW 1 Series f20
How to replace the remote control battery of BMW 1 Series f20
BMW Serie 1 (2011-2019 / MK 2, F21, F20) This guide shows how to replace the battery in the BMW 1 Series f20 remote control. To replace the battery, the first operation to be performed is to…
How to replace the headlight bulb of the BMW 1 Series F20
How to replace the headlight bulb of the BMW 1 Series F20
BMW Serie 1 (2011-2019 / MK 2, F21, F20) If you want to find out how you can replace the headlight bulb of your BMW 1 Series F20, just pay attention to the procedure described below. First, …

Other guides you may be interested in

How to Replace the Fan Resistor on a Renault Scenic

How to replace the fan resistor on a Renault Scenic. In this video, learn how to perform the disassembly: use a lever to remove the plastic under the glove compartment, and unscrew the cover (where the resistor is located) with a screwdriver. Disconnect the large connector of the resistor, then pull it out from the cabin. Insert a new fan resistor (connect the power connector). Finally, refit the cover and tighten the screws. Check the correct assembly of the previously fitted parts and test the correct operation of the fan.

Watch the video!


by ScegliAuto

More videos